Im sure this has been discussed before, but i wanted everyones input on where the best place is to buy belts? Online? Local?
↧
Best place to get belts!
↧
2014 rzr 1000xp needs HELP
New to the forum.
Rzr 1000xp taps out at 30mph at 6500 rpms floored at sand dunes. In the desert i can do 45mph at 6800-7200
All in high gear. In low gear rzr hit speed limiter at 30mph but gets up to 7200rpm in the sand. When i first bought the rzr it ran flawless then one day it was good next day it lost all power would barely putt around at 25mph. Starts fine on first turn of the key idles perfect at 1250rpms theres no hesitation no check engine light just wont go over 30mph at 6500rpms pinned to the floor.Listed below is what ive added and done to it. Ive been stumped for a while now. Any help is much appreciated
Brand new stm stage 3 primary (4 washers in the heel,
2 washers in the middle and no washers at toe)
Brand new stm secondary
Brand new oem belt
Fuel pump replaced
Spark plugs
Thank you
Rzr 1000xp taps out at 30mph at 6500 rpms floored at sand dunes. In the desert i can do 45mph at 6800-7200
All in high gear. In low gear rzr hit speed limiter at 30mph but gets up to 7200rpm in the sand. When i first bought the rzr it ran flawless then one day it was good next day it lost all power would barely putt around at 25mph. Starts fine on first turn of the key idles perfect at 1250rpms theres no hesitation no check engine light just wont go over 30mph at 6500rpms pinned to the floor.Listed below is what ive added and done to it. Ive been stumped for a while now. Any help is much appreciated
Brand new stm stage 3 primary (4 washers in the heel,
2 washers in the middle and no washers at toe)
Brand new stm secondary
Brand new oem belt
Fuel pump replaced
Spark plugs
Thank you
↧
↧
ATV Guru bumper question
Can anyone with a atv guru bumper give me the width of the top center bar from side plate to side plate. I would also like to know the dimension from the bar straight back to the plastic.A picture from the top looking straight down would be fantastic. I'm trying to figure out how much room there is to mount a light bar. Thanks in advance for any help!
↧
2018 1k xp help
Headlight indicator light lit on my speed cluster but my headlights arent on? I tried drying out the switch and disconnected the battery.any ideas? Thanks
Sent from my iPhone using RZRForums.net
Sent from my iPhone using RZRForums.net
↧
Low Speed Clutch Squeel - Solved!
I spent two years and more than $2,000 trying to solve the low speed clutch squeal on my 2017 XP1000. I had everyone involved, but no luck. I finally discovered it wasn’t even my clutch. The issue was a harmonic whine on my heat shield caused by a specific RPM. Two hose clamps around the heat shield and voila! No more low RPM squeal.
↧
↧
XP 1000 Handling Question
Thinking about a new Rzr and was talking with my dealer the other day about a 900 or 1000 S. I told him I liked the idea of being able to "steer with the rear" and drift through turns in our WV woods. I've been on demo rides and know this is easy to do with the A-Arm S models. He told me I should look hard at the XP1K because it comes with a front stabilizer bar now which reduces body roll and keeps the machine more planted. What do you think?
Below is a video from YouTube in which someone kicks the rear end out of the XP1K at almost every turn. Is this easily doable as illustrated in an 18 or 19 XP? I would rent one and try it out for a day, but none of the businesses around the Hatfield McCoy Trails seem to rent Rzr's.
Thanks for any input.
Below is a video from YouTube in which someone kicks the rear end out of the XP1K at almost every turn. Is this easily doable as illustrated in an 18 or 19 XP? I would rent one and try it out for a day, but none of the businesses around the Hatfield McCoy Trails seem to rent Rzr's.
Thanks for any input.
↧
Slowly coming together
Got my new 2 seater 1000 2 weeks ago, got the whips wired door bags, FANGS, i dont care if everyone thinks Im a poser. I HAD to get them!!
Sent from my iPhone using RZRForums.net
Sent from my iPhone using RZRForums.net
↧
CHECK OUT THIS TRANSFORATION
2019 XP1000....Cage built by Nine Eleven Fab in Ohio. Sedona beadlocks and 30" Rock A Billy's.
↧
Polaris Holiday Sales Event ends 12/31
I see that the holiday sales event for 2018 and 2019 model RZR's ends in a few days.
What does the collective think?, pull the trigger on a new machine in the next few days or wait and see if a better promotion comes along?
Dont need the machine immediately, as riding season is a few months off. Just looking to save a few bucks and put that money into accessories.
Anyone have and ideas on what the next promotion might be?
thanks for the feedback...
What does the collective think?, pull the trigger on a new machine in the next few days or wait and see if a better promotion comes along?
Dont need the machine immediately, as riding season is a few months off. Just looking to save a few bucks and put that money into accessories.
Anyone have and ideas on what the next promotion might be?
thanks for the feedback...
↧
↧
Do i need a clutch kit for 32 tires on rzr xp 1000
Rzr xp 1000 do i need a clutch kit for rzr xp1000 for 32 tires
↧
Xp transmission questions
Got the chance to pick up a couple XP transmissions that Im thinking about building up. Anything noteworthy between the different years I should keep in mind when buying ?
↧
2014 RZR 1000 Starting Problem
I have a 2014 RZR 1000 that I bought a few months back. Over the past few months I have broke one axle and two belts and changed the one way starter bearing twice. I have since fixed my belt issue. I just got back from River Run with it which was cut short due to my RZR having problems. It ran fine all night Friday and until about 5 oâclock Saturday when I heard what sounded like a grinding of gears. Those of you that have RZR have heard the grinding noise it will make if you canât have it in gear all the way and that is exactly what it sounded like. However no matter what gear I put it in it would not stop making the sound. After messing with in on the trail some I decided to just eas on back to camp. I was climbing over the moutain to go down and at the top it over heated so I killed it. After sittting for about 20 min it fired back up and killed it at the bottom of the moutain because it began to get hot again. I let it set over night and found the battery was dead in the morning. (It was the original battery) Now that I am back home I have bought a new battery and the RZR will turn over a little bit then hangs up however if I pull the spark plugs out it will continue to turn over constantly. Leading up to this problem I had been skating around through the moutain sin low at no more then 20mph. Any ideas what the problem could be?
↧
Polaris heater & subwoofer
Just installed the Polaris heater in my RZR. Has anyone had success installing the ssv glovebox subwoofer with the heater?
↧
↧
2018 xp turbo front axle issues
I having a problem with my front axle popping out the the diff. It seems to be happening almost every time I ride. Is this a common issue? Any suggestions on a fix?
↧
Who Has Done The Turbo XP Hood With Air Deflector
I ordered the Air Deflector for the Turbo XP and the Turbo Hood. I received the Deflector so far and the Turbo Hood should be here soon.
How have you guys installed the Air Deflector in a non TurboXP model? I have some ideas but wanted to see if anyone had done it first.
For reference I'm trying to get addidional cooling to the radiator becaus of the highlifter front bumper with winch mounted on top blocks a lot of air. I won't change the winch location or the bumper so I need to be creative with cooling.
How have you guys installed the Air Deflector in a non TurboXP model? I have some ideas but wanted to see if anyone had done it first.
For reference I'm trying to get addidional cooling to the radiator becaus of the highlifter front bumper with winch mounted on top blocks a lot of air. I won't change the winch location or the bumper so I need to be creative with cooling.
↧
S vs. xp front axle
Part number 1333946 calls out not only xp but also the S model. It supersedes 1333263. Can anyone verify the front axles are the same size? I need axles for my 16 S conversion.
↧
wheels
newb: 2016 1000xp new to me looking for non bead lock wheels for 30-10-14 tires in a 5/2 offset' Old guy so easy ridding and not wanting to break the bank. Looking at terrabite or chicana rx. Street and a little of everything else, learn as I go. This is just the first of many questions to come, thanks
↧
↧
Ride command group ride
Just bought 2019 xp 1000 2 seater with ride command, Bluetooth connected to my phone, installed the ride command app on my buddy's phone and my phone, created group ride, buddy joined, but can't see his position on app or ride command on rzr, anybody know what I did wrong? Thanks in advance.
↧
2015 gear reduction help
So I searched around the forums and found the part numbers to do the ace 325 gear reduction for my 2015 xp. Went to my local dealership and had them order it for me plus some new seals. The problem I now have is my old reverse chain doesnt fit anymore, it seems the new input shaft take a wider one than what I have now. Does anyone have the rest of the part numbers to do the wider chain? Also the part number for the input shaft seal if anyone has it saved.
↧
CAN THIS BE RELOCATED
I have a 2019 Ride Command. I want to install BrickCity's Bambino Front bumper. Can this be relocated? It sits on the cage support that the new bumper should be installed at.
![]()
Sent from my SM-G965U using Tapatalk
Sent from my SM-G965U using Tapatalk
↧